EX-1 is a blended Polymer modified cement based high performance tile adhesive. It has high bond strength and it's high water retention ability fixes all types of tiles on exterior/interior Wall and Floor very easily.
The surface to be tiled should be sound and thoroughly cleaned to make it free from wax, grease, polish etc.
Mix clearwater & EXTREMA in the ratio of 1:3. At site, adjust water according to desired consistency.
Always put adhesive into water & mix it with a trowel/slow speed drills
UNTIL A LUMP FREE HOMOGENOUS PASTE IS OBTAINED.
Spread the paste to a thickness of approximately 3-6 mm and comb with a notched trowel. Strictly apply the adhesive paste which can be tiled within 20 minutes.
Intermittently touch the adhesive paste on subtrate by finger. Ifthe adhesive sticks to finger then continue tiling. And if not, scrap off the adhesive and apply new coat.
Start laying the tiles on the surface. Tap the tiles properly with rubber hammer to ensure complete coverage of the backside of tiles and to eliminate the possibility of any air voids. Remove extra a dhesive from the edge of the tile for further laying.